#AUDIO REPEATER VIRTUAL AUDIO CABLE DRIVERS#
#AUDIO REPEATER VIRTUAL AUDIO CABLE SOFTWARE#

#AUDIO REPEATER VIRTUAL AUDIO CABLE SOFTWARE#

Long story short, between the latency introduced by the software and the clock timing differences between soundcards, you can really get anything usable. There is also a VAC/audiorepeater type program you can use called Soundflower, but like VAC it's really only for routing sound between apps, not between hardware. I haven't tried it, but I believe you can also make an aggregate device 'virtual' one and then set JACK to output to that device (the setup of which is too complex to explain here).Įach soundcard has it's own timing, and there's no way to keep them in synch, so you can control the latency and you'll have clicks, pops, dropouts, and tons of underruns. You can make a virtual soundcard using ALSA that can combine the outputs of two audio cards into one However, I am using usb headsets (digital) so I can't use audio sound card channels. and I need to be able to output audio from a PC to 2 devices simultaneously and have the inputs of both devices be valid recording devices. If more than one application sends audio streams to Virtual Audio Cable. 1 The problem I have is that I'm using Windows 7. The sound is delayed through each step in the chain, and the audio repeater latency can only go but so low before you get scratchy static and dropouts. The Audio Repeater application is the one that does the actual transfer, from the recording port to the other audio device. Now go into obs, and in the direct show audio source, set your audio input device to line 2 (Virtual Audio Cable). These scripts cover the two Audio Repeater applications (KS and MME) and the VAC Control Panel. In this program, set the wave in to line 1 (Virtual Audio Cable), and the wave out to line 2 (Virtual Audio Cable) and then press start. JAWS Scripts For Virtual Audio Cable ApplicationsDoug LeeLast Revised November, 2022 This document describes the scripts for Virtual Audio Cable applications.

One instance routes VAC1 to 'Onboard speaker out' and the other instance will route VAC2 to 'USB audio device out'. Now, go to Start > All Programs > Virtual Audio Cable > Audio Repeater (MME) 5.

(Since VAC1 or VAC2 aren't hooked up to real hardware, you don't hear anything.) Then you run 2 instances of audiorepeater.

So you can set up VAC to make 2 cables (VAC1 and VAC2). You can piggy-back that audio to different hardware devices by using the audiorepeater utility. The main category is Virtual Audio Cable software that is about Virtual Audio Cable software. You can use 'Virtual Audio cables' to create virtual devices that you can use for input and output between software. There are ways of cheating but they all stink in some way:

#AUDIO REPEATER VIRTUAL AUDIO CABLE DRIVERS#

Sound software has to access sound hardware through it's drivers and it can't handle 2 sets of calls to two different drivers (if someone has the proper tech jargon, please step in). You can assign discreet inputs and outputs but not multiple outputs across different audio devices.

Audio repeater virtual audio cable